CELVIN Q700 4.3.3 and Qcentral

FibreCAT SX, FibreCAT NX, FibreCAT TX, ETERNUS DX, ETERNUS LT, ETERNUS CS

Moderator: ETERNUS Moderator Team

CTX
Posts: 1
Joined: Sun Jul 22, 2018 17:38
Product(s): CELVIN Q700

CELVIN Q700 4.3.3 and Qcentral

Postby CTX » Mon Jul 23, 2018 17:20

After I upgraded to version 4.3.3 I got a permanent heavy CPU load (100% most of the time) and general low(terrible) performance.
Resource monitor shows "kernel_processes" taking >90% of CPU
I found that stopping Qcentral would get the system back to "normal" CPU load (now around 20%).
Qsync is one of the best and most used features nowadays with around 12 devices (PCs, laptops, androids, etc) conneting on and off to CELVIN/Qcentral.
I had no problems with previous versions.
I wouldn't like to downgrade - only as a last "solution" (?) !
But in fact I now have Qcentral switched off most of the time and connect it sometimes to allow synchronization.
Can you help ?
Best regards.

CTX

Return to “Storage solutions”

Who is online

Users browsing this forum: No registered users and 5 guests