PRIMERGY TX300 S7 IT mode/JBOD MODE

PRIMERGY, SPARC Enterprise Server, PRIMEFLEX, PRIMEPower, BS2000

Moderator: ModTeam

bucsaiakos
Posts: 1
Joined: Wed Dec 20, 2017 12:50
Product(s): PRIMERGY TX300 S7

PRIMERGY TX300 S7 IT mode/JBOD MODE

Postby bucsaiakos » Wed Dec 20, 2017 12:56

Dear Fujitsu support Team

My company recently bought a Fujitsu PRIMERGY TX300 S7 server from a second hand distributor.
Chassis Type: TX300S7F4
Serial: YLAX004934
BIOS Version: V4.6.5.3 R1.29.0 for D2949-A1x
System GUID: b0acbc51-8efb-264d-8988-c04fc4459ba4

We want to install Freenas operating system on it. It has D3116-B14 raid controller in it.
I try to switch it to JBOD mode in MegaCLI, but after i enabled it, the boot post stuck with B2 error code. When i switch off the JBOD mode, it is post normaly.

I try to replace the card to an LSI 9211-8i / Dell Perc H200 flashed in to IT mode.The card see the hard drives(12 drives 3TB), but i got the same B2 error at post.

Is there a way to use it in JBOD mode ? Or is there a HBA card which i dont get the B2 error.

Please help me to find a solution.

toomanylogins
Posts: 8
Joined: Sat Oct 07, 2017 17:00
Product(s): TX100 RX300

Re: PRIMERGY TX300 S7 IT mode/JBOD MODE

Postby toomanylogins » Sat Apr 14, 2018 14:08

I just created a logical drive raid 0 but with only one disk. Then it shows up in windows as a drive.


Return to “Server Products”

Who is online

Users browsing this forum: No registered users and 5 guests