I have a Primergy TX300 S5 Rack server. I decided to update bios, raid and irmc firmwares a few days ago.
I downloaded ASP files for Windows Server 2003 Enterprise (32bit) from drivers page with using serial number of server.
Bios updated successfully and rebooted the server. Then RAID firmware updated and rebooted server. (RAID 5/6 SAS based on LSI MegaRAID 256MB)
Finally I executed the ASP file for IRMC and it failed. Then I rebooted the server. It took so long to start and fans were blowing at high speed.
In IPMI Status page of bios it says irmc firmware is not installed.
- bios ipmi.jpg (71.42 KiB) Viewed 4260 times
I prepared a usb stick to install irmc and booted the server with this stick. Tried to update irmc with "Normal" option and it failed. (Execution of BMC/IPMI command 'GetDeviceID' failed)
- irmc flash - normal.jpg (52.6 KiB) Viewed 4260 times
Then tried with "Recovery L" option and it failed. (Cannot chech for system type. Error code = 0x100a)
- irmc flash - recovery_l.jpg (89.64 KiB) Viewed 4260 times
In windows os I created a diagnostic report. There is an error as "Chassis Model not found" and there is no sensor data such as voltages, temperares, fans etc.
How can I install IRMC again?