Hi Davie and thanks
I have followed these steps correctly. The problem is further.
Firstly I enable the RAID in BIOS. After I create the RAID 1 with Ctrl-M. State: Optimal
Now I boot de server with ServerView CD. When finish the installation wizard, I get and "Server Internal Error" and the installation don´t begin. I can´t do native install.
Then, I try with Windows CD. In the installation wizard I use the driver from Support Fujitsu "LSI Logic Embedded MegaRAID" and I see only one logical drive. I make one partition and th installation begins.
I can finish the installation of the SO. In the SO, in the Disk Manager Console, appear two physical disks again, and ServerView RAID Manager does not detect the controller or physical disk or logical volume.
In Device Manager Console, in item "Storage controller", appears "Controller SATA RAID Controller Intel C600 Series Chipset". I try to update the driver of the device and I use the driver from Support Fujitsu "LSI Logic Embedded MegaRAID". It´s the same I used in SO installation wizard. The update is sucessful, and the device change to "LSI Logic Embedded MegaRAID". I must reboot, but the server will not start anymore, only install again.
In the Fujitsu Support site there´s no information, or any further driver, or information in the manuals.
I tried to install Server 2008 R2, and everything worked correctly. I have a single logical volume and can monitor the status of the raid with ServerView RAID Manager. It's the only solution I see now, but I have to check if I can make a downgrade of the operating system .