wireless keyboard on Scenic P320

[denys06]

Hello,
I am just trying to make a wireless keyboard (MicroSoft Wireless Multimedia Keyboard 1.1) working on a Fujitsu Siemens P320 (YB3E009828).
But it seems the keyboard is not recognized at boot : 2 bits + message "0211 : Keyboard error, Press <F1> to resume , <F2> to Setup".
For info, the wireless kb works fine if a PS/2 kb is also connected during the boot, but it's not actually what I would wish to do.
Anyone would advise ?
Thx.
denys06

[sabrex]

Make sure you go into bios and check:
Peripheral Configuration:
USB Host Controller Enabled
USB 2.0 Host Controller Enabled
USB Legacy Support Disabled by default the usb legacy is disabled you must ENABLE this option.

Save and exit
done

[denys06]

Thank you Sabrex for your answer...
However those 3 options about USB were already all 3 set to "enable" in the BIOS.
Regards,
denys06

[denys06]

PB SOLVED
To whoever it may concern : the USB cable of the base has to be plugged into a USB connector of the motherboard, not on another USB plug, for instance on a PCI extension card.
Regards,
denys06