[M9400] DVI

Moderator: ModTeam

kaba1ah
Posts: 3
Joined: Tue May 20, 2008 14:48
Product(s): M9400

[M9400] DVI

Postby kaba1ah » Tue May 20, 2008 15:47

Hi-

I have one M9400 plugged into Port Replicator (ESPRIMO Mobile Port Replicator) with SCENICVIEW A17-3A connected to Port Replicator using DVI cable. The thing is that when I turn on laptop I don't see anything on external monitor, like FS logo or BIOS boot menu - SCENICVIEW reports that there is no signal. As soon as Operating System boots up (actually when Intel 965GM drivers are initialized) then I got a picture on external monitor, but not during boot time. It's not a big problem because I can use VGA cable, it works OK with VGA, but I just would like to confirm whether this is a normal behavior? If I plug Esprimo Mobile U9200, using the same port replicator and monitor - it works as expected both with DVI and VGA cables, I get constant output on SCENICVIEW during and after boot process.

Any advice would be highly appreciated.

thomasmebes
Posts: 1
Joined: Tue Jan 06, 2009 14:14
Product(s): 9410

Re: [M9400] DVI

Postby thomasmebes » Sun Jan 11, 2009 16:13

|


Return to “ESPRIMO Mobile”

Who is online

Users browsing this forum: No registered users and 0 guests