For five years I am using the S935 with a Port Replicator at home and another at my office. On both Port replicators I have the same ports used, for each 2 identical monitors, same wireless (bt dongles on USB ports) keyboards and mouse, and one USB for a special card reader, and of course LAN and power supply.
Everything functioned wonderful until Friday last week.
When I tried to start the S935 in my home port replicator on Sunday, no signal was detected by the monitors attached to the port replicator. And LAN did not work as well (although the LAN a such was available). But: the USB-Portreplication worked since mouse and keyboard worked perfectly. Power supply via the port replicator worked as well.
When I started the S935 in my office port replicator on Monday, no signal was detected by the monitors attached to the port replicator. And LAN did not work as well (although the LAN a such was available). But: the USB-Portreplication worked since mouse and keyboard worked perfectly. Power supply via the port replicator worked as well.
On both locations I experienced a second fault: the keyboard of the build in keyboard deviates from its earlier function as well as from the keyboard connected via USB. The latter are still working fine. But the build in keyboard not:
when you push button 0, the display shows a /
when you push button p, the diplay shows a *
Thus, my conclusion is:
either there is a driver problem, i.e. I should reinstall the relevant drivers again,
or something in the the port replication female socket of the S935 has a problem.
How can I verify or perhaps even solve this problem?
First, I would like to try a re-installation of the drivers - which should I re-install, and where do I get them?
Thanks for help!