wireless keyboard on Scenic P320

Moderator: ModTeam

denys06
Posts: 11
Joined: Sat Jul 30, 2011 18:54
Product(s): Scenic P320 SIS661+

wireless keyboard on Scenic P320

Postby denys06 » Thu Aug 04, 2011 20:45

Hello,
I am just trying to make a wireless keyboard (MicroSoft Wireless Multimedia Keyboard 1.1) working on a Fujitsu Siemens P320 (YB3E009828).
:( But it seems the keyboard is not recognized at boot : 2 bits + message "0211 : Keyboard error, Press <F1> to resume , <F2> to Setup".
:) For info, the wireless kb works fine if a PS/2 kb is also connected during the boot, but it's not actually what I would wish to do.
Anyone would advise ?
Thx.
denys06

User avatar
sabrex
Posts: 1145
Joined: Thu Jun 05, 2003 0:01
Product(s): Various
Location: England
Contact:

Re: wireless keyboard on Scenic P320

Postby sabrex » Fri Aug 05, 2011 10:35

Make sure you go into bios and check:
Peripheral Configuration:
USB Host Controller Enabled
USB 2.0 Host Controller Enabled
USB Legacy Support Disabled by default the usb legacy is disabled you must ENABLE this option.

Save and exit
done

denys06
Posts: 11
Joined: Sat Jul 30, 2011 18:54
Product(s): Scenic P320 SIS661+

Re: wireless keyboard on Scenic P320

Postby denys06 » Fri Aug 05, 2011 11:11

Thank you Sabrex for your answer...
:cry: However those 3 options about USB were already all 3 set to "enable" in the BIOS.
Regards,
denys06

denys06
Posts: 11
Joined: Sat Jul 30, 2011 18:54
Product(s): Scenic P320 SIS661+

Re: wireless keyboard on Scenic P320

Postby denys06 » Sun Aug 07, 2011 9:18

PB SOLVED
To whoever it may concern : the USB cable of the base has to be plugged into a USB connector of the motherboard, not on another USB plug, for instance on a PCI extension card.
Regards,
denys06


Return to “SCENIC”

Who is online

Users browsing this forum: No registered users and 2 guests