Every time my R640 boots up just after Mouse initialized I get the following
System Configuration Data updated
ERROR
System Configuration Data Read Error
Press <F1> to resume, <F2> to Setup
I have tried to flash the BIOS with latest update, I have used the BIOS recovery CD with the jumper on the board, attempted to use Default settings. Every time it comes back to this. If I chose F1 the system continues, and boots up, seems to work properly. If I disable Stop on Error, it will show the same message, then after a couple seconds continue to boot.
I also removed half the memory at a time to test all memory. Ran FSC diagnotics and it found no problems.
Any ideas?
Thanks,
Steve