[R640] System Config Data Read Error

Moderator: ModTeam

SteveB
Posts: 1
Joined: Sat Feb 07, 2009 0:12
Product(s): R640

[R640] System Config Data Read Error

Postby SteveB » Sat Feb 07, 2009 4:02

Every time my R640 boots up just after Mouse initialized I get the following
System Configuration Data updated
ERROR
System Configuration Data Read Error

Press <F1> to resume, <F2> to Setup

I have tried to flash the BIOS with latest update, I have used the BIOS recovery CD with the jumper on the board, attempted to use Default settings. Every time it comes back to this. If I chose F1 the system continues, and boots up, seems to work properly. If I disable Stop on Error, it will show the same message, then after a couple seconds continue to boot.
I also removed half the memory at a time to test all memory. Ran FSC diagnotics and it found no problems.

Any ideas?

Thanks,

Steve

Return to “CELSIUS Workstations”

Who is online

Users browsing this forum: No registered users and 1 guest