I've got a fujitsu celcius R610 workstation. This can run dual xeons at 3.0ghz. I've got two 2.8ghz xeons installed at the minute. The prob is it wont boot. I've checked everything so far like. Changed CPU, installed 1 CPU, tested RAID setup & disks. Setup on IDE disks and my problem seems to be pointing to the RAM installed.
According to the manual this machine takes 266mhz DDR PC2100 RAM but for some reason its got 333mhz DDR PC2700 RAM in it. It wont boot all i get is all the fans spinning, disks spinning. Looks as if its going to boot but no. If i move the RAM into another slot it beeps at me.
It beeps 4, then 3, then 1, then 2.
I'm sure its down to the RAM. Can some of the tecchie people have a think for me before i go and spend some money on some RAM?