Hello,
I have the problem connecting to SX80 management ports. I can't connect neither to https nor to ssh ports. When I'm connecting to https, web browser just doesn't load the page. When I try to connect through ssh I get the error:
ssh_exchange_identification: Connection closed by remote host
After using the command "ssh -vv 10.10.10.179" I've got the response:
OpenSSH_4.3p2, OpenSSL 0.9.8b 04 May 2006
debug1: Reading configuration data /etc/ssh/ssh_config
debug1: Applying options for *
debug2: ssh_connect: needpriv 0
debug1: Connecting to 10.10.10.179 [10.10.10.179] port 22.
debug1: Connection established.
debug1: permanently_set_uid: 0/0
debug1: identity file /root/.ssh/identity type -1
debug2: key_type_from_name: unknown key type '-----BEGIN'
debug2: key_type_from_name: unknown key type '-----END'
debug1: identity file /root/.ssh/id_rsa type 1
debug1: identity file /root/.ssh/id_dsa type -1
ssh_exchange_identification: Connection closed by remote host
Earlier I had only the problems with https. I used to restart management controllers through ssh and then https started to work normally. After some time (weeks) I noticed that https doesn't work again. Then I used to repeat the above procedure and everything worked fine again.
One possible reason I can think of is that this SX80 is put behind the Barracuda Load Balancer 340 (working as a router too). I configured the services in Barracuda to have the possibility to access the management ports of SX80. The problem could rise from the point that the Barracuda uses "TCP Port Check" every 60 seconds to be sure that the service is still available. I changed this setting to 3600 but I can't test it so easily - the SX80 is about 300 km away. Of course I have the possibility to access the SX80 remotely "from inside network".
Maybe someone encountered this before and have the solution?
Regards,
--
Vytas