FibreCat sx80 Not able to see new disk in Windows

Moderator: ETERNUS Moderator Team

tmi
Posts: 2
Joined: Mon Apr 14, 2008 12:51
Product(s): fibrecat, primergy, lifebook

FibreCat sx80 Not able to see new disk in Windows

Postby tmi » Fri Jan 23, 2009 12:06

I have a windows server 2003 connected to an SX80 and use one disk on the san. Now I have installed a new disk and a new volume in the SX 80, and configured the san/volume so it should be seen from the Windows Server, but the new disk is not visible from Windows, but I see the old disk/volume. I need to see both at the same time to copy all the files from the old disk to the new. The new disk is configured with another LUN than the old one, but I have tried it withe the same Lun too, it makes no difference. The FC card in the server is a LP101.
Has anyone a solution to this problem ?

FSC830
Posts: 121
Joined: Tue Dec 09, 2008 10:07
Product(s): Pocket Loox T830

Re: FibreCat sx80 Not able to see new disk in Windows

Postby FSC830 » Fri Jan 23, 2009 14:06

Hi,
did you really configured the host mapping? If all settings are correct Windows should see the disk. Sometimes I realized that a disk rescan will not work, but after a reboot the disk must be accessable.
Check all settings again, take also a look at the drivers parameters.
Regards


Return to “Archive”

Who is online

Users browsing this forum: No registered users and 2 guests