Reset BIOS to factory defaults on RX200 S8

PRIMERGY, SPARC Enterprise Server, PRIMEFLEX, PRIMEPower, BS2000

Moderator: ModTeam

siposkaroly
Posts: 1
Joined: Wed Jan 25, 2017 15:08
Product(s): RX200 S8

Reset BIOS to factory defaults on RX200 S8

Postby siposkaroly » Fri Jan 27, 2017 8:28

I have misconfigured the BIOS with UEFI and CSM settings. Since that I can not enter the BIOS Setup Menu. Now I want to reset to factory defaults with setting jumper J9 on the mainboard. But it isn't clear what should I do after setting the jumper. Should I power on or not.
The manual says nothing about is.

jofo
Posts: 9
Joined: Mon Jan 02, 2017 9:29
Product(s): Fujitsu Primergy TX150 S8
Location: SV

Re: Reset BIOS to factory defaults on RX200 S8

Postby jofo » Fri Jan 27, 2017 11:01

Is it perhaps possible to access the BOIS by accessing the iRMC S3 and set the boot device: "BIOS Setup"

Tom_A
Posts: 64
Joined: Wed Sep 28, 2016 10:28
Product(s): ESPRIMO Q920

Re: Reset BIOS to factory defaults on RX200 S8

Postby Tom_A » Tue Jan 31, 2017 9:51

Typical BIOS recovery jumper usage is to:
-Power off
-Move jumper to RCV position
-Power on
-Enter BIOS
-Power off
-Move jumper back to normal position
-Power on

Remember to disconnect the PC from the main power outlet before accessing the main board.


Return to “Server Products”

Who is online

Users browsing this forum: No registered users and 2 guests