PRIMERGY, SPARC Enterprise Server, PRIMEFLEX, PRIMEPower, BS2000
- Posts: 1
- Joined: Wed Jan 25, 2017 15:08
- Product(s): RX200 S8
I have misconfigured the BIOS with UEFI and CSM settings. Since that I can not enter the BIOS Setup Menu. Now I want to reset to factory defaults with setting jumper J9 on the mainboard. But it isn't clear what should I do after setting the jumper. Should I power on or not.
The manual says nothing about is.
- Posts: 9
- Joined: Mon Jan 02, 2017 9:29
- Product(s): Fujitsu Primergy TX150 S8
- Location: SV
Is it perhaps possible to access the BOIS by accessing the iRMC S3 and set the boot device: "BIOS Setup"
- Posts: 64
- Joined: Wed Sep 28, 2016 10:28
- Product(s): ESPRIMO Q920
Typical BIOS recovery jumper usage is to:
-Move jumper to RCV position
-Move jumper back to normal position
Remember to disconnect the PC from the main power outlet before accessing the main board.
Return to “Server Products”
Who is online
Users browsing this forum: No registered users and 1 guest