BX924 S2 and SX960 S1 blade servers will not power on through the management blade or by manually pressing the power button on the blade servers. They are receiving power and the power button is amber in color. In each blade server, I have to re-seat the CMOS battery, power on the server, boot into the BIOS, change all settings to default and reboot. The servers are not affected if they are rebooted. Only when powered off.
I also tried putting in blade servers that have never been in the BX400 chassis before. Same result.
Is there a way to update and/or reset the firmware to default on the BX400 chassis?
Everything in the management blade shows that the servers should power back on after a power loss, and are not set to go into S3 sleep.