If no iSCSI target LUN is displayed in this menu, there are two possible
- The iSCSI parameters in the controller’s firmware setup do not match the
corresponding parameters in the configuration of the iSCSI target. In this
case you will need to check the iSCSI parameters in the controller’s
firmware setup (see chapter "iSCSI Boot Configurations" on page 25),
and restart the Windows setup.
- No drivers or incorrect drivers were installed. Make sure that the correct
drivers are installed.
LAN: Intel 82574 L (Onboard on PS160-D2759-A1x)
Users browsing this forum: No registered users and 1 guest