PRIMERGY, SPARC Enterprise Server, PRIMEFLEX, PRIMEPower, BS2000
- Posts: 5
- Joined: Tue Oct 14, 2008 11:23
- Product(s): Econel
Numerous times after updating the server OS and requiring a reboot, the server will hang at the BIOS (BIOS as shipped not updated). The annoying thing is that iRMC is also affected so I cannot access the BIOS remotely to cycle the power again. The other annoying this is it isn't consistent, sometimes the server will reboot fine.
It is odd because the BIOS should be accessible even at power off via iRMC so cannot understand why when it hangs I cannot access it.
The server will sit there indefinitely which is annoying. The only way to fix the issue is to remove both power leads from the back then reboot and hope it comes back up. This is a major issue for me as it means a 60 miles round trip to do this.
Has anyone else experienced the same problem.
- Posts: 567
- Joined: Fri Jun 10, 2005 0:01
- Product(s): PRIMERGY, ServerView
- Location: UK
You almost answered it yourself! It is almost certainly the iRMC that is hanging - which causes the reboot to hang, because the iRMC is responsible for rebooting the server!
The RX300 S8 has an iRMC S4 and early versions of the firmware had a problem that caused it to slow down until it stopped completely.
Removing the power leads causes the iRMC to reboot and so it's OK again for a while until the problem recurs.
All versions of iRMC firmware up to about 7.68F were affected - current is something like 8.05F
Update the iRMC firmware and all should be good
Return to “Server Products”
Who is online
Users browsing this forum: No registered users and 1 guest