sb11a. configuring pin-group

PRIMERGY, SPARC Enterprise Server, PRIMEFLEX, PRIMEPower, BS2000

Moderator: ModTeam

o-o
Posts: 2
Joined: Wed May 27, 2015 9:25
Product(s): RX300S8

sb11a. configuring pin-group

Postby o-o » Wed Jun 10, 2015 13:13

I am trying to adjust the pin-group.
I insert two downlink and one uplink interface to the pin-group.
But the pin state shows: pinning. And the traffic does not forwarding between downlink ports.

What has been done:

Code: Select all

(BX400S1001877-CB2) #whichboot


Boot-System....................... EHM
Next Booting Mode................. EHM


                       file name      file type startup size (byte)
-------------------------------- -------------- ------- -----------
           sb11a-b-1.04.0131.biz Boot-Rom image       Y      389229
                     default.cfg    Config File       Y       22267
        sb11a-sw-r-6.30.0611.biz Operation Code       Y     8558462


(BX400S1001877-CB2) #configure
(BX400S1001877-CB2) (Config)#pin-group test
(BX400S1001877-CB2) (Config)#interface 0/2
(BX400S1001877-CB2) (Interface BX400S1001877-CB2/0/2)#pin-group test
(BX400S1001877-CB2) (Interface BX400S1001877-CB2/0/2)#interface 0/20
(BX400S1001877-CB2) (Interface BX400S1001877-CB2/0/20)#pin-group test
(BX400S1001877-CB2) (Interface BX400S1001877-CB2/0/20)#interface 0/43
(BX400S1001877-CB2) (Interface BX400S1001877-CB2/0/43)#pin-group test
(BX400S1001877-CB2) (Interface BX400S1001877-CB2/0/43)#exit
(BX400S1001877-CB2) (Config)#exit
(BX400S1001877-CB2) #show pin-group test

Auto VLAN Uplink Synchronization............... Enable

Repinning Timer................................ 10

Name                  Uplink Ports            Downlink Ports
--------------------  --------------------    --------------------
test                  BX400S1001877-CB2/0/43  BX400S1001877-CB2/0/2,
                                              BX400S1001877-CB2/0/20

(BX400S1001877-CB2) #show pin-group test detail

Auto VLAN Uplink Synchronization............... Enable
Pin Group Name................................. test

Downlink Ports          Selected Interface      Pin State
--------------------    --------------------    ----------
BX400S1001877-CB2/0/2                           Idle
BX400S1001877-CB2/0/20                          Idle


"Admin mode" back to "Enable" on ports 2,20.

Code: Select all

(BX400S1001877-CB2) #show pin-group test detail

Auto VLAN Uplink Synchronization............... Enable
Pin Group Name................................. test

Downlink Ports          Selected Interface      Pin State
--------------------    --------------------    ----------
BX400S1001877-CB2/0/2                           Pinning
BX400S1001877-CB2/0/20                          Pinning

Return to “Server Products”

Who is online

Users browsing this forum: No registered users and 1 guest