[RX300 S6] Fan control

PRIMERGY, SPARC Enterprise Server, PRIMEFLEX, PRIMEPower, BS2000

Moderator: ModTeam

Varsius
Posts: 2
Joined: Mon Oct 19, 2020 16:40
Product(s): Fujitsu Primergy RX300 S6

[RX300 S6] Fan control

Postby Varsius » Thu Nov 05, 2020 15:19

My goal is to reduce the noise and save a little bit of power of my Fujitsu Primergy RX300 S6.

In the BIOS I only found options to reduce the energy consumption of the cpu and ram.

I am using Proxmox as my OS and already installed "ipmitool" which works great for reading sensor data.

I tried following this guide(https://www.spxlabs.com/blog/2019/3/16/ ... dge-server) to lower the fan speed. Unfortunately the ipmi raw commands do not work on my server (I thought ipmi was standardized).

When I try to run

Code: Select all

ipmitool raw 0x30 0x30 0x01 0x00
in order to enable manual fan control, I get the follwing error:

Code: Select all

Unable to send RAW command (channel=0x0 netfn=0x30 lun=0x0 cmd=0x30 rsp=0xc7): Request data length invalid


I would really appreciate if someone could help me lower the fan speed of my server or could provide me a source of the approriate ipmi raw codes.

Thanks a lot in advance, Varsius

User avatar
Ask Fujitsu
Moderator
Posts: 234
Joined: Fri Aug 02, 2019 10:02
Product(s): n/a

Re: [RX300 S6] Fan control

Postby Ask Fujitsu » Mon Nov 09, 2020 10:25

Hello! :D

Thank you for your post on the Official Fujitsu Forum!

We would like to inform you, that the described issue requires deeper analysis and hence it might be necessary to provide logs, journals, reports and/or any other additional information which are necessary in the troubleshooting process. Please bear in mind, that the Official Fujitsu Forum is public and nothing that contains confidential information cannot be posted on it.

Due to this, please submit a ticket to Fujitsu's Technical Support via one of the given options:

1. Using the contact form available on the site: https://support.ts.fujitsu.com/IndexContact.asp?lng=COM tab "Contact us").

2. Contacting one of our ServiceDesk Office in your country. Please visit https://support.ts.fujitsu.com/IndexContact.asp?lng=COM and click "Your Service Desk" tab. You can find contacts to each Fujitsu's Technical Support divisions on the world there.

3. Sending an email to address: technical.support@ts.fujitsu.com. Message sent should contain the below information:

- Product ID or serial number of your device
- Operating system on the device
- Description of failure
- Changes of Hardware or Software configuration before malfunctioning of the system

Thank you,
Primergy Technical Support Team

toomanylogins
Posts: 18
Joined: Sat Oct 07, 2017 17:00
Product(s): TX100 RX300

Re: [RX300 S6] Fan control

Postby toomanylogins » Wed Mar 31, 2021 18:48

Did you find a solution to this ? I would like to reduce speed of fans on rx300 S7
Paul


Return to “Server Products”

Who is online

Users browsing this forum: No registered users and 1 guest