Usb Connection to my D1627 board

All topics related to PC

Usb Connection to my D1627 board

Postby jnnw » Sat Aug 27, 2005 21:49

Hi. I have a atx case with two usb front ports and speaker + mic sockets. i was wondering if you could help me connect these leads to the motherboard as i have no instructions from my case. these are the wires for the two usb ports:<P>D2+ (Red)<BR>D2- (brown)<BR>D3- (Blue)<BR>D3+ (Green)<BR>GND (Orange)<BR>GND (Yellow)<BR>Power (Black)<P>And the Speaker + Mic are:<BR>SPK L<BR>GND<BR>MIC<BR>SPK R<BR>GND<P>Sorry For the long message! Image<P>I Will be very greatful if any of you could reply and where these plugs are ment to go. Thank you<P>Regards<P>Jason

Posts: 1233
Joined: Wed Jun 11, 2003 0:01

Re: Usb Connection to my D1627 board

Postby Juggernaut » Sun Aug 28, 2005 23:11

<BLOCKQUOTE><font size="1" face="Verdana, Arial">quote:</font><HR>Originally posted by jnnw:<BR><B><BR>D2+ (Red)<BR>D2- (brown)<BR>D3- (Blue)<BR>D3+ (Green)<BR>GND (Orange)<BR>GND (Yellow)<BR>Power (Black)<BR></B><HR></BLOCKQUOTE><P>Are you sure? Normally GND is black and Power is red/orange/yellow<P>Anyway, in the manual there is an exact pin-out of the mainboard:<BR> <A HREF="" TARGET=_blank></A> <P>This should help to connect all wires right...<P>

Return to “Personal Computers (archive)”

Who is online

Users browsing this forum: No registered users and 1 guest